News

1. preparation tools Prepare a wrench, an iron rod (an auxiliary installation), a cleaning agent, a hammer, and other tools 2. take the U type mounting plate Remove all pin shafts on the mechanical clamp, and take down the U type mounting plate and the related bolts. 3. pin shaft pin shaft The operating excavator reacts the shaft hole of the bucket and the crushing clamp, inserts the pin shaft and tightens the fixed bolt. (due to unevenness of the ground lead to the use of an iron hammer to insert the pin shaft when the installation is not smooth) 4. Connecting rod pin shaft The elongated bucket oil cylinder coincides with the shaft hole of the connecting rod and the crusher, inserts the pin shaft and tightens the fixed bolt.(due to unevenness of the ground lead to the use of an iron hammer to insert the pin shaft when the installation is not smooth) 5. installation of U type mounting plate The rear end of the bucket is installed with the pin of the pin shaft to make the tail of the crusher close to the bottom of the bucket.Adjust the bottom contact plate to keep it close to the bottom of the bucket Insert the U type mounting plate and adjust the mounting plate to close it to the top of the bucket rod of the excavator.Adjust the bolts above the U plate to ensure the consistency of the left and right fasteners. Adjust the bolts below the U plate to ensure the consistency of the left and right fasteners. Finally, make sure that all the bolts are tightened. 6. Try to run and check if there is any interference Before the test run, check again whether the U type mounting plate is close to the bucket or not, otherwise it is easily damaged by unequal force.The maximum elongation and the contraction bucket oil cylinder check whether the U type mounting plate interfered with the body or the cylinder. If there is any interference, please let us know how to deal with it.